text-only page produced automatically by LIFT Text Transcoder Skip all navigation and go to page contentSkip top navigation and go to directorate navigationSkip top navigation and go to page navigation
National Science Foundation Home National Science Foundation - Office of International and Integrative Activities (IIA)
Office of International and Integrative Activities (IIA)
design element
IIA Home
About IIA
Funding Opportunities
Awards
News
Events
Discoveries
Publications
Career Opportunities
View IIA Staff
IIA Organizations
Integrative Programs and Activities
International Science and Engineering (ISE)
Office of Experimental Program to Stimulate Competitive Research (EPSCoR)
Proposals and Awards
Proposal and Award Policies and Procedures Guide
  Introduction
Proposal Preparation and Submission
bullet Grant Proposal Guide
  bullet Grants.gov Application Guide
Award and Administration
bullet Award and Administration Guide
Award Conditions
Other Types of Proposals
Merit Review
NSF Outreach
Policy Office
Other Site Features
Special Reports
Research Overviews
Multimedia Gallery
Classroom Resources
NSF-Wide Investments

Email this pagePrint this page

Discovery
Plasma Waves Studied for New Electronics

With NSF support, long-time electrical engineer William Stillman talks about his return to school and the focus of his research involving terahertz radiation

Photo of William Stillman in the lab evaluating the effects of focused terahertz radiation.

William Stillman evaluates the effects of focused terahertz radiation on ring oscillator circuits.
Credit and Larger Version

July 1, 2009

Who says you can't teach an old dog new tricks?

After nearly 25 years as an electrical engineer in semiconductor development and manufacturing, I headed back to school as a trainee with the National Science Foundation's (NSF) Integrative Graduate Education and Research Traineeship (IGERT) program.

The focus of my research involves terahertz radiation--about which I knew very little when I first arrived on campus. Until recently, the terahertz portion of the electromagnetic spectrum has mainly been of value to studies of atmospheric and astronomic phenomena, such as mapping the changes in the Earth's ozone layer and peering into the origins of the universe. Now, though, applications are exploding.

Terahertz radiation is part of the electromagnetic spectrum, just like sunlight, radio waves, X-rays and gamma rays. Terahertz frequencies are between 0.3 and 30 trillion cycles per second, leading to some very interesting properties.

For one, terahertz radiation tends to pass through many common things like paper, cardboard, leather and fabric, to more exotic materials, like the sprayed-on foam insulation of the space shuttle, and it's reflected by metals and many ceramics. This makes it really good at finding hidden objects, such as weapons hidden under clothing at the airport or defects in the adhesion of that shuttle foam (which could lead to failure during launch).

Since terahertz radiation wavelengths are in the range of 1 to 0.01 millimeters, good image resolution is possible, and yes, in case you're wondering, this brings up privacy issues, which are a hot debate at the moment.

While we're on the subject of imaging--since the radiation frequencies coincide with many vibration modes for molecules, not only can you see that something is hidden, you can figure out what it's made of. For example, you can see whether the powder contained in an envelope is talc or methamphetamine, or whether an improvised explosive device is made from dynamite or more powerful plastic explosives.

However, terahertz radiation is nearly completely absorbed by water, including moisture in the air, so the standoff distance--how far away we can see those threats--is limited to about 100 meters (328 feet).

For some applications, this limited transmission distance is an advantage, such as for secure tactical communications, where long signal ranges increase the likelihood of interception. Similarly, it is the difference in cellular water content, and hence terahertz absorption, that allows identification of cancerous tissue in medical applications.

Although deep tissue scans, like X-ray scans, are not possible, analysis can be performed on excised samples. And unlike X-rays, terahertz radiation is non-ionizing, so repeated exposure does not pose a health risk.

With all of this potential, why aren't terahertz applications all over the place? One reason is the available power of terahertz sources. Compared to a typical mainstream FM radio station, running at 100 kilowatts, terahertz-source power tops out in the range of a few hundred milliwatts.

The difficulty in coming up with high-power terahertz sources lies in the frequency range: it's "too fast" for electronic sources and "too slow" for optical ones. The low power of available sources puts a significant burden on the other side of the equation--the sensitivity of the terahertz detector. While atmospheric and astronomic applications have long relied on running detectors at cryogenic temperatures and converting terahertz signals to lower frequencies (downconverting), the lion's share of earth-bound applications really have to operate at room temperature and, oh, by the way, they need to be fairly small and fairly cheap.

Certainly, detectors are available today, namely pyroelectric devices--in which heat energy is converted to an electrical signal due to a change in material polarization. And there are compound semiconductor (C.S.) Schottky diodes, in which non-linear operating characteristics turn the received signal into a DC voltage.

Both of these devices have their limitations, though: pyroelectric devices are on the slow side and C.S. Schottky devices are difficult to integrate with complex integrated circuits. If only there was a way to make conventional transistors operate at terahertz frequencies.

Enter plasma-wave electronics, the topic of my research. The speed of conventional, transit-time silicon Field-Effect Transistor (FET) operation is limited to roughly 0.5 to 0.8 terahertz (even with nanoscale devices).

Electron plasma waves are localized, time-varying perturbations in the electron concentrations in the FET channel. Think of them as waves on a pond when you toss in a pebble.

First proposed in 1973 by Michael Dyakonov and my thesis advisor, Michael Shur, plasma-waves are expected to allow silicon FETs to operate as high as 10 terahertz! In our lab, we've demonstrated detection from 0.2 to 1.6 terahertz with these devices, and terahertz detectors based on silicon FETs will be easy to integrate with complex image processing circuits.

In the process of our research, we've found a way to apply terahertz radiation to testing large scale integrated circuits, memory chips and microprocessors for defects and traits that can hamper performance.

However, the most rewarding aspect of my research, by far, is the collaboration with my peers and mentors. And, our research group has a strong international component. I've grown from my experiences here tremendously. I received my doctorate in electrical engineering this past May, and am continuing my research as a post-doctoral research associate. On top of all of this, last semester, I had the opportunity to teach a sophomore year physics class as an adjunct professor. Quite a few new tricks for this old dog!

-- William Stillman, Rensselaer Polytechnic University stillw2@rpi.edu

This Behind the Scenes article was provided to LiveScience in partnership with the National Science Foundation.

Investigators
William Stillman
Michael Shur

Related Institutions/Organizations
Rensselaer Polytechnic Institute

Locations
New York

Related Programs
Integrative Graduate Education and Research Traineeship Program

Related Awards
#0333314 IGERT: Terahertz Science and Technology - A Studio-Based Approach

Total Grants
$3,904,902

Related Websites
Technology: Behind the Scenes: Plasma Waves Studied for New Electronics: http://www.livescience.com/technology/090612-bts-terahertz-radiation.html

0.2 THz response map (left) and detector response simulation (right) for a 120 nm NFET.
A 0.2 terahertz (THz) response map.
Credit and Larger Version

0.2 THz response map (left) and test device photograph showing approximate peak locations (right).
Part of a test device photograph showing approximate peak locations.
Credit and Larger Version



Email this pagePrint this page
Back to Top of page